OMNI AR-15 Lower Receiver Questions

A

areader

Member
EE Expired
Rating - 100%
2   0   0
Location
Ontario
Hey guys,

So I started by next ar build today. I completed my OMNI Hybrid AR15 lower receiver but for some reason the trigger pins i used dont come flush on either side of the receiver. Is there special pins that need to be used with this lower receiver?

Second question, the upper receiver I'm going to be building is going to be chambered in 7.62x39. Will this be an issue with the OMNI lower receiver?
 
Question 1:mine didn't either.....on one lower,and stuck out past the receiver on another(I bought 4),had no issues with either function wise.

Question 2:ran a 10.5" PSA 7.62 on one of mine for 3000 plus rounds with no issues.its my go to gun for new shooters because it cost me so little and runs cheap surplus ammo,and I don't look after it,it's been dropped more time then I can count,fallen off the shooting table after a newbie has leaned it up in the rack,he'll it even had a buffer get jammed into the extension and I had to smack the stock off the ground a few times to get it to return,there's no cracks,or issues with it so far.

Mines and gen1 by the way,no steel inserts for reinforcement
 
You must log in or register to reply here.
Back
Top Bottom