Optics for Ruger Precision Rifle ?

[Rocket_James]

I am looking for suggestions for my new optics for a Ruger 308 Precision Rifle that I just bought. I would like to shoot out to 300 yards.

Also, would I be able to use this scope on other rifles or does this waste too much time in setup? Any information and discussion on cost and quality would be appreciated.

 

[BadAsMo]

Well... Every picture Ruger ever posted on the RPR shows it with a Burries XTR II scope. I'd start there if I were you.

I have 2 of them and I think they represent good value...

If you will be swapping it among rifles... I'd get a one piece QD base.

I'd consider the one piece PEPR mount from Burris. The 34 mm version of the PEPR mount does not come in a QD model. If you want a QD base there are others... like Larue... but that one chews your rail.

For a 34mm qd one piece base that does not chew your scope rail you'll probably end up here... I don't have one of these, but will probably replace my Larue with one of these some day.

https://www.rdsc.ca/products/american-defense-recon-scope-mount-34mm-qd-lever

 

[bsand]

I actually swap over my scope (tangent theta) between my 22 and 308. I just use ATRS rings and they are good to go. No QD required. I usually just dial up for the 22, and dial back down for the 308. Its usually within 0.1 mrad.