Pachmyayer flush mount sling swivel

If we are talking about the ones shown below, try western gun parts. But be aware there was at least one size change over the years.

 
They look just like that .The 2 sizes are not interchangeable i'am guessing? I can get the flush cup out so the size change not be a big deal as long as the outside of the flush cup is the same size.Thanks for the info.
 
Not sure about the cup size itself. Either way Erv at western gun parts should be able to help you out. I want to say the newer ones are too big to fit in the older browning 78 cups.
 
I have a used set of flush mount cups marked Pachmayr and a used set of swivels that are too large to fit the Pachmayr cups... so I am assuming the swivels are the latest heavier version.

I'll mail them in an envelope for $20. They do not fit one another.

IMG-4176.jpg
 
Last edited:
Well after looking at the info double gun posted and getting the flush cup out of my rifle I'am sure it is the older generation with no taper.It looks like the flush cups guntech post a picture of are the 1st generation as well so the sling swivels won't fit but thanks for the offer and the info guntech. So I'am still on the hunt for a 1st gen swivel or 2. Thanks everyone for the info .Jared
 
It's going to be very hard to find the old lighter ones that kept breaking... there was a reason they made the newer ones larger.

If it were mine I would remove them and make some nice ebony plugs and install real studs into them.
 
I bought a stock second hand that had the older swivel cups already installed, but no swivels. It's been a while, but I'm pretty certain that the newer style cups are not a simple swap out with the older. Iirc, I had to take mine to a smith and he did some wood removal to get the new ones to fit.

Good tip from Guntech... I might look into that myself. I never did warm up to the Pachmayr's all that well.
 
You must log in or register to reply here.
Back
Top Bottom