well, the title says it all, anyone done it yet?
my question is this, after seeing one yes the finish is better, but it couldn't hurt it to be finished better still.
and John if you see this i'm sure i now know what your talking about with some things you probably wanted changed.
1. dust cover door installed with proper "e"clip?
2. maybe a proper fire control group, not the funky one finger thing they use?
3.proper mag well bevel?
4. hand guards, that fit properly
5. proper crush washer for flash hider
6. proper spec. gas tube, the one i seen will not allow a mil-spec bolt carrier to fit.
and finally the main one i think, which is what this post is about, if you want to paint your norc, is it legal to stamp the serial number into the lower reciever before paint/dura coat? the one i've seen just has the munbers painted on.
any answers and comments both positive and negative are welcomed
my question is this, after seeing one yes the finish is better, but it couldn't hurt it to be finished better still.
and John if you see this i'm sure i now know what your talking about with some things you probably wanted changed.
1. dust cover door installed with proper "e"clip?
2. maybe a proper fire control group, not the funky one finger thing they use?
3.proper mag well bevel?
4. hand guards, that fit properly
5. proper crush washer for flash hider
6. proper spec. gas tube, the one i seen will not allow a mil-spec bolt carrier to fit.
and finally the main one i think, which is what this post is about, if you want to paint your norc, is it legal to stamp the serial number into the lower reciever before paint/dura coat? the one i've seen just has the munbers painted on.
any answers and comments both positive and negative are welcomed
