Possum hollow .223 trimmer
- Thread starter P-J
- Start date
)
I ordered it right from Eric the Possum Hollow guy, said he had one to ship me when i called and gave him CC info.
In a couple weeks when I get it I will see how it works. I will pre-size them all on a FL sizing die, then all the shoulders should be uniform and it should trim them all to the same length. I will do a few hundred and post back results.
With just neck sizing, wouldnt that bring in variance?? Thats what the possum guy told me, best results with FL sizing before hand. haha I don't know, for 40$ shipped we'll see. I hate trimming brass.
In a couple weeks when I get it I will see how it works. I will pre-size them all on a FL sizing die, then all the shoulders should be uniform and it should trim them all to the same length. I will do a few hundred and post back results.
With just neck sizing, wouldnt that bring in variance?? Thats what the possum guy told me, best results with FL sizing before hand. haha I don't know, for 40$ shipped we'll see. I hate trimming brass.
This thing made my life easier. It is definitely quicker. You have to run through your brass three times (trim, inside/outside chamfer) but it seemed way quicker with this tool.
Accuracy seems to vary +/- .002 but that's fine.
Did 250 cases in a hour, not bad at all compared to what I was doing before.
Accuracy seems to vary +/- .002 but that's fine.
Did 250 cases in a hour, not bad at all compared to what I was doing before.
