powder measure
- Thread starter twig_40
- Start date
Mystic Precision
CGN Ultra frequent flyer
- Location
- Summerland, BC
There isn't a powder measure on this planet that will drop long grain extruded powder to under +/- 0.2gr accuracy.
Some of the finer grain powders like Benchmark, can be metered quite well. Usually to 1 or 2 tenths either way.
Depending on your application, that could be accurate enough.
Jerry
Some of the finer grain powders like Benchmark, can be metered quite well. Usually to 1 or 2 tenths either way.
Depending on your application, that could be accurate enough.
Jerry
There is a "Dillon precision powder baffle" you can buy for USD$7 from UniqueTek. Looks like this:
http://www.uniquetek.com/site/696296/product/T1278
I bought one. Haven't installed it. Talked to a guy at UniqueTek about it. In theory, it will reduce the difference in dropped mass you might see between when your hopper is 1/4 full compared to 3/4 full, for example. I figured it was a cheap experiment but I haven't gotten around to installing it yet but there are some reviews around the net.
http://www.uniquetek.com/site/696296/product/T1278
I bought one. Haven't installed it. Talked to a guy at UniqueTek about it. In theory, it will reduce the difference in dropped mass you might see between when your hopper is 1/4 full compared to 3/4 full, for example. I figured it was a cheap experiment but I haven't gotten around to installing it yet but there are some reviews around the net.
