Pressure levels for a NEWER Shiloh Sharps

[358Scout]

Considering getting one in 45-70.

I have a Marlin 95 which is rated for Level 2 loads, the Ruger #1 is rated for Level 3 loads.

Can a Sharps take a Level 3 smokeless powder load ?

 

[burnt_servo]

your safest bet would be to maybe contact the people who built the rifle .

a ruger #1 is a pretty strong rifle

 

[c-fbmi]

The Shilo Sharps is capable of any load the Ruger is. My 45-110 Long Range Express has digested 500 gn jacketed loads at a chronographed 2200 fps. Case capacity and pressure virtually identicle to 458 Lott, cases popped out like a 15,000 PSI black powder load.

 

[hickstick_10]

The owner of the outfit Kirk Bryan I beleive his name is, will tell you and has told others his sharps will take a ruger#1 45-70 load. http://www.shilohrifle.com/forums/viewtopic.php?t=2726

I still dont put em in mine, mostly because a 535 graine bullets or heavier are all I can tolerate with no sissy pad shooting prone.

 

[Mark-II]

I've always stuck with the trapdoor loads in my Pedersoli because I was unsure of the strength of the action, modern or not. Interesting to see the Shiloh being stronger than I thought

 

[hickstick_10]

There is speculation that the italians use a different steel for their sharps then Shiloh. The shilohs are 4140 and no one realy knows what the italian ones are made of but some are thinking 8620.

 

[22to45]

How does 8620 compare to 4140?

 

[hickstick_10]

Depends on the heat treatment.

youl get 57000 psi yield when annealed accourding to this source http://www.onlinemetals.com/alloycat.cfm?alloy=8620
4140 oil quenched and tempered you could get 212000 psi and annealed youl get 60000 psi, but I dont think Shiloh is going to tell us how they handle their receivers as far as a heat treat goes.

 

[sail32]

Check web site www.bpcr.net in the technical articles section for information on pressures and steels.

 

[gunlaker]

According to Kirk at Shiloh they will, but it sure won't be very much fun

Chris.