Pulling Bullets and Recylcling

[Bluffton Bill]

OK,

So in an earlier post I had a problem with inconsistant performance due to improper seating depth (Barnes TSX's in my 300 mag). I have 50 rounds loaded up that I need to pull. My question is that once I have pulled the bullets out can I simply dump the powder, recharge the primed cartridge with a different powder, and reseat a different bullet without resizing everything?

 

[Boomer]

I doubt that you need to, but for piece of mind it wouldn't hurt just to true up the necks. If you do, make sure to check your primers after. If the vent hole in the die is plugged, the compressed air might push the primer part way out.

 

[Bluffton Bill]

Check.

Thanks for all of the help Boomer.
Appreciate it.