Quick help for rcbs turret.

kendo

kendo

CGN Regular
Rating - 100%
54   0   0
Location
kebec,republik,YUL
i have install my rcbs turret press with 6 stations, 3 dies for 9mm, and the uniflow powder measure install on the top plate. It is normal, when i want make a 360 , turn with the plate, the poder measure hit the hole, in the base of the press? the same with the decaping pin, on my first die,yesterday i had broke a pin.
Any help will be appréciated!!!
 
Yes i have adjust the die, with the ram at the top of the stroke,the die with the décaping pin, with my news adjustement, is close to be perfect to clear the base of the press. But my powder measure,need close to one inch to clear it! But later, i am gone post some pics,to be more specific, my english is so so, ans my explanations too ;o)))))

But when i put a empty brass, and move the ram to the top, the measure level is good enough to drop the powder, thanks again!
 
If pics can help,here it come ;o)))
press.jpg


I have adjust the dies, for the powder at top, but it need a manual help for clearance.
 
Last edited:
I'm not familiar with that set up but it looks like the powder drop is set too low. I'll look online and see if I can find something for you.

edit....try starting at this video (multi parts) and it might mention something. I didn't watch them all so I can't say if it will help or not. Link
 
Last edited:
KDX, thanks for the link, is there a lot of info,i am go back my reloading bench, and check and then check again,But i still smiling, i have a lot of patience;)))))))
 
You must log in or register to reply here.
Back
Top Bottom