Couldn't find the post from Slavex but I remember seeing a picture he posted with brass set screws securing down Model 2000 that is quite wobly even with the supplied plastic pieces:
that by the way have no clue where the bottom one is supposed to fit
Anyway I replaced the brass set screws from Slavex' photo with 1'' 10-24 nylon screws that fit perfectly well with the one already on the holster. I measured the outside diameter of the nylon screws and took a smaller drill bit. Drilled 2 holes and threaded the holes using a metal 10-24 screw. Then I screwed in the nylon screws and cut them to proper lenght. I then sanded the screws with fine grit sand paper and voila, it's sturdy now
that by the way have no clue where the bottom one is supposed to fit
Anyway I replaced the brass set screws from Slavex' photo with 1'' 10-24 nylon screws that fit perfectly well with the one already on the holster. I measured the outside diameter of the nylon screws and took a smaller drill bit. Drilled 2 holes and threaded the holes using a metal 10-24 screw. Then I screwed in the nylon screws and cut them to proper lenght. I then sanded the screws with fine grit sand paper and voila, it's sturdy now
