Rail for Fixed FSB AR?
- Thread starter GundamZero
- Start date
There's so many options, if you want a drop I unit;
KAC RIS/RAS
DD Omega 7.0
Surefire M73
Troy Battlerail
If you're up to removing the handguard ring and want to extend the handguard;
KAC MRE
DD RIS II FSP (I have specifically this right now)
DD Omega-X 12.0 FSP
VTAC/Troy Delta Rail
Amongst the slew of other options, most of which are Chinese garbage.
[DD RIS II FSP]
KAC RIS/RAS
DD Omega 7.0
Surefire M73
Troy Battlerail
If you're up to removing the handguard ring and want to extend the handguard;
KAC MRE
DD RIS II FSP (I have specifically this right now)
DD Omega-X 12.0 FSP
VTAC/Troy Delta Rail
Amongst the slew of other options, most of which are Chinese garbage.
[DD RIS II FSP]
There's so many options, if you want a drop I unit;
KAC RIS/RAS
DD Omega 7.0
Surefire M73
Troy Battlerail
If you're up to removing the handguard ring and want to extend the handguard;
KAC MRE
DD RIS II FSP (I have specifically this right now)
DD Omega-X 12.0 FSP
VTAC/Troy Delta Rail
Amongst the slew of other options, most of which are Chinese garbage.
[DD RIS II FSP]
This is what you want, OP. I have one I could sell you, if you'd like, but it's black
how hard is it to replace the barrel nut, for someone who has never done it??
84wh1
CGN Ultra frequent flyer
Its really easy.
1- Remove plastic clam shell handguard
2- Remove gas block A2 sight assembly by driving out the taper pins. Just make sure you tap them out the right way as they are tappered
3- Get proper barrel nut wrench and remove barrel nut by simply unthreading it with the wrench
4- Pull barrel off & remove old barrel nut/ delta ring assembly
5- Slide on the new barrel nut & re install A2 front assembly
6- Attach new handguard per manufacturers direction
You can also remove the gas tube and then take the barrel nut off and then remove the A2 front sight assembly with the barrel removed. Either way works
Its not hard at all. Just make sure to get a quality wrench and vice block/ Bev block/ reaction rod.
