Railed forend for Rem 1100 12ga

[badboybeeson]

So working on a project with a US company, we came up with somthing Canadian shooters may be intrested in

Railed forend for the remington 1100.
who would be intrested in this?
It will be made from machined 6061 T6 Mil Spec hard anodized finish.
Very very light, less then 25% heaver then the factory forend.
No gunsmithing install.
whos willing to sign up for some of these.
simon

 

[manbearpig]

estimated price?

 

[badboybeeson]

estimated price?

$135-150

 

[Milsparro]

Well, not worthless, but definitely better!

 

[badboybeeson]

Prototype

 

[twoshots]

I`ll take one if it fits the 11-87 as well

 

[manbearpig]

are all the ports necessary?
under the rough use a tactical gun might see, wouldnt that potentially introduce a lot of dirt/grit into an already sensitive gas system?

 

[badboybeeson]

I`ll take one if it fits the 11-87 as well

Ill have the check on that.
bbb

 

[sixty9santa]

I would have preferred round holes vs slots, cuts down on machining cost a bit too.