RCBS Decapping pin

[jwk]

I have a set of dies for a 300WM and I noticed that the decapping pin is loose,Is there a way to tighten the pin or is it suppose to be like this?Thanks

 

[t-star]

the decapping pin should be replaceable- or at tleast it is in my 308 wcf dies- undo the knurled knob on the top and the entire stem should come right out- on the bottom of that stem you'll find a collar - tighten that down and it should hold your decapping pin- btw, if you can't find decapping pins, you can use a finishing nail and grind the heand and point off- it's not the best solutiuon, but it works

 

[jwk]

Thanks t-star! I will try that.

 

[fogducker]

if you want a bit of a stronger pin....use a drill bit..
you can cut them with a small grind stone