Rear Sight on STG-44 (.22lr)

S

Skeletor68

Regular
Rating - 0%
0   0   0
Location
Wainwright
Is there a way of raising the rear sight (Iron Site) with a small washer? I want to keep the rear one low and not worried about breaking it off while checking the targets and the rifle is on my back with a sling.
 
You can easily enough depress and slide the rear leaf out, remove two screws and take the sight off. I personally have put 2 1/16th thick washers under the sight to raise it at the suggestion of others online. Ive yet to see if it works but the 1/8th inch rise is all you essentially need from what ive learned/seen. You will need to shave down one set of washers to get them to fit, youll see what i mean when you get the leaf and sight off
 
I did this^^. With 2 washers (generic ones, don't know the thickness) under each screw, my rear sight is at the lowest setting and shoots right on at 25 yards.
 
You must log in or register to reply here.
Back
Top Bottom