Rear Sling Stud Install?

[Mark Mags]

Hey guys,

Looking for some quick and easy advice here....

Looking to add a rear sling stud to my 870+V3. However, these were in the parts bin, and I don't know what size bit to use.

So...anyone here know what size bit to use for a course thread rear stud?

 

[TacticalTeacher]

Uncle Mikes drill bit set from Brownells......quote:

For Easy, Clean Swivel Stud Holes

Easy to use, carbon steel drill bits contain a special relief tip to help prevent wood splintering and break-out when drilling sling stud holes. Features a built-in counter-sink for precise inletting of the stud spacer and a flush fit every time. Pre-set, drill-depth indicator prevents drilling too deep and ruining the hole. Includes two drill bits, 5/32" dia. and 3/16" dia., for both front and rear stud holes.

Hope this is handy!!

Enjoy the addiction...

Cheers, Barney

 

[kamlooky]

Awww yesth, the chippith finish as the screw'd eye-bawl becomes tight.
Gaaaad, I hate that happen'in.

 

[Mark Mags]

Done! One went good, the other is adequate.

Thanks for the info

 

[struff55]

Bubba strikes again .