Recoil pad for curved butt?

[ninepointer]

I have a Remingtom 760 with a factory butt-plate (no pad). The butt of the stock has a slight curve to it. Is there a recoil pad (grind-to-fit or pre-fit) that I can install without having to cut the stock flat?

 

[SuperCub]

None that I know of. What caliber?




.

 

[ninepointer]

None that I know of. What caliber?




.

.308 Win. I'm looking to extend the length of pull on the rifle.

I see that Brownells has a Hogue EZG grind-to-fit pad with a "polymer buttplate that flexes to fit less than perfect stocks". Wonder if this would work?

 

[stocker]

If you put a standard recoil pad in lightly boiling water for about 10 minutes you can then curve it to fit. Just flex it gently against the curve of the stock. You can actually over curve it a slight amount by lifting the ends a bit while maintaining pressure in the center against the stock and eventually allow screw pressure to flatten the ends rather than curve it too little. Hold in place while it cools and sets in that shape. Did I mention it will be hot and gloves are a good thing?

 

[guntech]

Pachmayer F325 pads will bend... warm them up...

 

[tinker]

I just put a Pachmayer pad on a curved stock,bent to the curve no problem.
Frank