I had trigger issues with my 597. It seems to have been a fairly common one where a retaining washer didn't fit properly and I could shoot about 50 rounds then take the assembly out, push the washer back in and keep shooting. So I sent it to the Canadian warranty center. They didn't have any new replacements, Rem USA said they were backordered too, but the warranty center said the gunsmith had a used one that he had tested and it was fine. I just want to shoot, don't care if I get a used part back as long as it works so I told them to send it.
Put the new assembly in today and off to the range. I would have one FTF every other a mag. Figured maybe I was riding the trigger and not allowing it to reset. It was shooting nice, a big ragged hole at 20 yds with bulk blazer ammo.
Then I had a slam fire? Pulled the trigger and 3 rounds went off. I had previously adjusted the the retaining screws so that the rails were straight, and the only trouble I was having before this was the trigger issue that I had sent in for warranty. Could the refurb trigger cause this problem?
I also posted this on rimfire central for those of you that browse over there.
Put the new assembly in today and off to the range. I would have one FTF every other a mag. Figured maybe I was riding the trigger and not allowing it to reset. It was shooting nice, a big ragged hole at 20 yds with bulk blazer ammo.
Then I had a slam fire? Pulled the trigger and 3 rounds went off. I had previously adjusted the the retaining screws so that the rails were straight, and the only trouble I was having before this was the trigger issue that I had sent in for warranty. Could the refurb trigger cause this problem?
I also posted this on rimfire central for those of you that browse over there.


















































