Rem 7615 aftermarket stocks

[Hydroformed]

Where Can I get a pistol grip stock for my Rem 7615 other than down under?

 

[Greenhorse six]

Don't Rem 870 stocks fit the 7615 , IIRC the 20ga ones , unsure about 12ga .

 

[lone-wolf]

Don't Rem 870 stocks fit the 7615 , IIRC the 20ga ones , unsure about 12ga .

I had a blackhawk(Knoxx) 20ga stock for the one I had, fit perfect - a good addition.
I do think the 12ga stocks fit as well, but are wider than the receiver and will look funny.

Fun rifle.

 

[gallen270]

the rear of the 7615 receiver is the identical to an 870 20 gauge. 12 gauge 870 AR15 stock adapters are commonly used on them, it will overhang the receiver slightly, being made for a 12 gauge, but not so much its really gawdy looking. Any 870 pistol grip should also fit.

 

[Can-down]

I made a 20g to 12g adapter out of a 12 gauge aluminum single sling loop using a hand file till it fit into the receiver.

 

[P0WERWAGON]

i had an original Brobee adapter on mine. i have since switch to the MesaTactical

 

[gallen270]

i had an original Brobee adapter on mine. i have since switch to the MesaTactical

is that fore end aftermarket from the aussies, or did you somehow modify the factory parts.

 

[P0WERWAGON]

made my own railed fore end then i covered it in magpul.

 

[canadaman30]

I believe the 7615 has the same receiver as the 7600,7400,750. What ever aftermarket parts for them fit

 

[Can-down]

made my own railed fore end then i covered it in magpul.

Did you modify the original or fabricate from scratch?
Custom Barrel as well.... might as well tell us the whole story.....

 

[P0WERWAGON]

stripped down the fore end. found a tube the exact size to slide over the OEM one. had three rails installed and an end cap welded on. now it bolts onto the action bars.

10inch barrel custom made using the barrel extension from the 16 inch one. rest is obvious.

 

[Can-down]

Nice work, How's the bark with the short barrel....
Have you tried a short vertical fore grip?

 

[P0WERWAGON]

same as my 10 inch AR. just numb, no moving action. weird sensation.

a short grip would just torque on the action bars too much a wreck it. the magpul panels i put on a grippy enough anyways

 

[Can-down]

Thanks for the confirmation.....I was thinking that the torque might be an issue on the slide assembly.