Remington 710 bolt question

[LE303]

Remington 710 in 7 mm mag . Shoots and cycles fine . I read all the posts I could stand about the bolts sticking . My problem is .. Fire it and the bolt handle kicks up ??? . Sometimes maybe 1 / 4 inch ?? it has a scope so I didn't notice it really till some one was standing next to me watching me shoot . Is this common . I don't wanna ask if its bad . I think its not good . Any tips , advice , help , fixes ?? Before I take it in to a smith . If this is bad or common . I will go something else 7 mm mag . But have no idea what to get that would be better . Not interested in off shore stuff ( other then Enfields or SK,s ha ha ) only domestic brands ie rem win moss .. LE303
Ahem , not sure how to delete , my guy says they all do it by design

 

[brybenn]

The 710 is not a high quality rifle and are plagued with several issues. I would upgrade if I was you. Savage 110/111 is a great rifle for decent money. I have several and they're very accurate

 

[hakx]

The 710 is not a high quality rifle and are plagued with several issues.

This. Stay away from the 770's as well.

 

[LE303]

I sent your email to the armoury their response is below:

Totally normal, nothing to be concerned about
Hmmm , I sent a email detailing the issue and asking if a flaw or if just how they work . The above was the one sentence reply I received

 

[Hitzy]

When it's in the fired position, is there 1/4" of up and down slop?

 

[blasted_saber]

There are reports of the bolts on 710s coming entirely out of the reciever when the gun is discharged.

You couldnt pay me to use that gun. I quite like my fingers and eyeballs.

 

[LE303]

dry , snap cap or fire an actual round . After firing the bolt handle kicks up a bit . Is sloppy at the bottom 1/4 inch , but you have to over come the action , to move bolt up and back to cycle it .
https://youtu.be/JTQtGbtzkRw
at about 3.05 and 3.30
https://youtu.be/4fLzWTu2uSE
doesn't do it