Remington 870 ghost ring sights

[camnorth]

Hi,
Can anyone offer affordable options for ghost ring sights for a Police receiver that has 4 holes drilled and tapped? I’ve been searching the web but doesn’t seem there are too many options being sold here in Canada that are with a rail. I’m assuming I need a rail as most rear apertures are affixed to 1 or 2 holes only.
I can post pics if anyone needs reference points. Also if anyone has something available for resale you can PM me please.
Thanks everyone

 

[sky52]

Vang comp. From brownells

 

[Butcherbill]

Doesn’t XS sights offer a rail with a built in adjustable peep for the 870?

 

[RePete]

Check with Casey at Tac Ord.

 

[EL34/6L6]

XS railed sights. I have them on all my 870s.

 

[KND]

My favorite ghost ring sight for 870 is Wilson Combat. Very low profile and easy to install. Look it up on Google.

 

[camnorth]

XS railed sights. I have them on all my 870s.

Very nice collection there. Does the XS railed sight come with a front sight as well? Are there any suggested retailers in Canada?

 

[EL34/6L6]

Very nice collection there. Does the XS railed sight come with a front sight as well? Are there any suggested retailers in Canada?

Gravel Agency or Brownells would be your best source. They can be ordered with a Tritium front sight too but a barrel with an elevated front ramp sight is best IMO.

 

[RePete]

My favorite ghost ring sight for 870 is Wilson Combat. Very low profile and easy to install. Look it up on Google.

This is what it looked like when I purchased it, and then after I installed the Wilson Sights.

 

[Rebel Rouser]

Casey @ Tac Ord has a few different sight manufactures in stock, it's just not on his website.

 

[Leg]

RePete, is that a factory 18.5” vent rib barrel? Nice looking shotgun.

Did you customize the front sight or do they sell one for vent ribs? I think I’d heard of that in the past but I’ve never seen it on their website or in Brownell’s.

 

[RePete]

RePete, is that a factory 18.5” vent rib barrel? Nice looking shotgun.

Did you customize the front sight or do they sell one for vent ribs? I think I’d heard of that in the past but I’ve never seen it on their website or in Brownell’s.

No, it was a 28" cut back to 19", crowned and I had to mill a small piece from the rib to get the front sight to sit on the barrel. Prior to cementing the sight on, I drilled the sight and rib for a roll pin. I didn't use the supplied cement, I used JB Weld.