Remove CZ858 folding stock

[Pacifist]

Can anyone tell me how to get that GDF screw out of the folding wire stock on my CZ 858? I have the FAB M4 stock I want to replace it with but that screw will not budge. I have trying all the stuff I have seen on the net but nothing has worked. Is the wrench they used to put this thing on available anywhere or am I going to have to get a piece of tool steel and grind it to fit?

 

[kb007]

Impact driver and the right sized bit. Mine came out in seconds that way.

 

[johnsks]

I had to put some heat to the inside of the receiver

 

[4307]

spray PB Blaster let soak, then use impact gun.

 

[IMR4320]

get the widest flat screw driver you can get and set it in good so you don't strip it. Then find a way of getting an extra torque on that driver(cross wrench, some form of a lever) and go for it. Brute force is the answer.

 

[bigbang]

Liquid wrench and a tire iron worked for me

 

[st1264]

Impact driver and the right sized bit. Mine came out in seconds that way.

This ^. Had to buy a socket specially for this as mine would not budge at all. Worked after I found the right tool. Them suckers are tight in there. I never liked shooting with the folding stock, found it uncomfortable.