Removing a CZ-858 stock

[Fallenrock2]

I have dripped oil around the bolt but I am still just about stripping it when I try to take it out. Any suggestions?

 

[scuitto]

There a post with pics here somewhere?? with mine I had to grind down a flat blade (socket) so it would fit.

 

[Fallenrock2]

Do you have a link to that thread?

 

[Doc911]

http://www.canadiangunnutz.com/forum/showthread.php?t=145278&highlight=CZ-858

 

[joe n]

I had to use either a tire iron ground to the size of the screw, or my largest flathead. Very first thing I did though was to put some heat onto her, that is all it took! Good luck!
Joe

 

[skirsons]

Smash that beaver-puke stock to pieces. Then pick them up and throw them into the garden, where wood-chips belong.

I used a dremel, so... not exactly smashing. That's just a fantasy.

 

[P0WERWAGON]

i used a "easy-out" from MAC. it has a 9/16 hex drive and the other end has a spiral to the left. just used a long extension and spun it out. no damage to the bolt or stock.

 

[scuitto]

http://www.canadiangunnutz.com/forum/showthread.php?t=145278&highlight=CZ-858

That how I did mine worked slick

 

[johnsks]

I modified a tire iron after every thing else failed and after more swearing that worked