Anyone have any ideas on removing the factory finish on a CZ? Looks like it's been chipping, so I figured a removal and re paint is in order. Is there any tried and true method or can anyone post a old link? I used the search function but didn't come up with anything.
Removing CZ factory finish
- Thread starter Duncan71
- Start date
Travis Bickle
CGN Ultra frequent flyer
- Location
- Upper Lower Middle Alberta
I owned one a while back.
I had sand blasted the finish off completely.
Then degreased, acetoned and cera-kote sprayed it. Using the oven bake type.
Looked bad ass. Very durable, turned a flat textured black. I sold it years ago after shooting the unholy s**t out of it.
I'll try and dig up an image.
I had sand blasted the finish off completely.
Then degreased, acetoned and cera-kote sprayed it. Using the oven bake type.
Looked bad ass. Very durable, turned a flat textured black. I sold it years ago after shooting the unholy s**t out of it.
I'll try and dig up an image.
Three types of paint? That is too thick. Only one layer ceracoat or duracoat does the job.
Before and after with duracoat parker
