Removing Tikka action from an MDT Tac21 Chassis? Help please.

4

45C

CGN Ultra frequent flyer
Super GunNutz
Rating - 100%
160   0   0
Location
Canada
Hello,
I’ve ran into a road block trying to remove my tikka barreled action from the MDT chassis.
Can’t get the safety out through the slot.
And I can’t see where I can remove the bolt shroud?
Any help would be appreciated.

Brian
 
Blastattack said:
Generally yes. Disassembly is usually the exact reverse of installation. Did you follow the installation instructions in reverse?
Click to expand...
I didn’t install it but yes I did follow the instructions on disassembly.
I couldn’t get the bolt stop pin out .
I let the chassis go with the gun as I had enough of trying to remove that pin.
There’s really no way to get at that pin out other than trying to shake it loose or pick at it with a small screw driver.

Seems like a bad set up ,
 
You must log in or register to reply here.
Back
Top Bottom