Resize After Swaging

[Sniffer]

I just picked up 1000 IVI 556 cases from a forum sponsor. Looks like its been deprimed & tumbled but not swaged (crimped primer).

Looks like I have 1000 cases to swage with my Dillon 600 (this is gonna take a while but luckily its a one time thing).

I did a handful tonight and got to thinking that I should resize again after the swaging is complete as the case mouth will have gotten expanded a little with the flair on the pin that goes inside the case.

I could just neck size on my single stage - what does everyone else do?

 

[just having some fun]

Pin on the 600 should not touch the mouth of the case... or not enough to matter

 

[dirtybarry]

I just picked up 1000 IVI 556 cases from a forum sponsor. Looks like its been deprimed & tumbled but not swaged (crimped primer).

Looks like I have 1000 cases to swage with my Dillon 600 (this is gonna take a while but luckily its a one time thing).

I did a handful tonight and got to thinking that I should resize again after the swaging is complete as the case mouth will have gotten expanded a little with the flair on the pin that goes inside the case.

I could just neck size on my single stage - what does everyone else do?

Resize every single piece of brass acquired from any source no matter what somebody says was already done to it. Is it all trimmed to my specs, does it all fit in my chamber? There is only one way I know of to be absolutely 100% sure.