wonder if you guys can help me figure this out, i have been reloading for a few years now and never ran into this before .I use to reload for 308 and got aset of 308 rcbs dies i sold the rifle and have not reloaded that cal for a few
years now have a new 308,so i go to reload a batch 50 once fired federal.
Every thing seemed fine till i went to trim them on my rcbs trimer the pilot would not go into the neck checked right sized pilot right shell holder even
rechecked the die setup and did a couple more cases.The o.d the neck is smaller then spec,and so is the i.d .Unresized case necks are just like they
should be the bullet falls in .What happened i have used these dies before and they were ok ,i cleaned them before using and i lubed the necks .
I Used my 30-06 dies and set up to just neck size the top bit of neck and that worked but now the necks are long Iknow i have to trim.
HELP!
years now have a new 308,so i go to reload a batch 50 once fired federal.
Every thing seemed fine till i went to trim them on my rcbs trimer the pilot would not go into the neck checked right sized pilot right shell holder even
rechecked the die setup and did a couple more cases.The o.d the neck is smaller then spec,and so is the i.d .Unresized case necks are just like they
should be the bullet falls in .What happened i have used these dies before and they were ok ,i cleaned them before using and i lubed the necks .
I Used my 30-06 dies and set up to just neck size the top bit of neck and that worked but now the necks are long Iknow i have to trim.
HELP!
