Just wondering if some one has this scope and can tell me what ring hight they used. I have a Rem 700 5r with a egw 20moa rail and just picked up a Falcon 5.5-25x56 for it and am not sure what i need for ring hight. Thanks for any help. cheers
Ring hight for falcon 56 ml scope
- Thread starter badlands
- Start date
canucklehead
CGN Ultra frequent flyer
- Location
- Calgary, AB
I have almost the same setup as you. Falcon 4.5-18x56, on my Rem 700 VS with Near 20MOA base.
Believe it or not, I'm running TPS Lows. They are about the height as most other mediums, and it leaves a little less than 1/8" clearance from the bell to the barrel.
If the 5.5-25 is quite long and you run a sunshade, you MIGHT run into some issues due to the 20MOA base (ie: the front of the scope will be lower than the rear), but I would suspect you'll be fine.
Believe it or not, I'm running TPS Lows. They are about the height as most other mediums, and it leaves a little less than 1/8" clearance from the bell to the barrel.
If the 5.5-25 is quite long and you run a sunshade, you MIGHT run into some issues due to the 20MOA base (ie: the front of the scope will be lower than the rear), but I would suspect you'll be fine.
Thank you for your help,i was thinking i would need a high or med. Cheers
