Rob XCR flash Supp.
- Thread starter carlchevalier
- Start date
A Pinned and Welded flash hider (muzzle device) does not effect the Firearms classification does it?
The barrel still has to be 18.5"+ to be non-restricted.
It can't be 18" with a 1" flash hider welded on and be considered 19" can it?
The barrel still has to be 18.5"+ to be non-restricted.
It can't be 18" with a 1" flash hider welded on and be considered 19" can it?
the barrel refers to the threaded amount. the currently threaded bit it what .5 .6 inches... if it's .61 after being chopped the barrel is no longer 18" and I think that changes the class....
I'd have to look up the regs.. But
I have one of the XCR's that came in with the light (3.5#) trigger and the ambi-saftey.The flashhider on it was removed by grinding the weld that holds the pin in. The weld will look like a small raised "bump" on the bottom of the flashhider. Once the weld is removed (very minimal grinding) an educated whack with a rubber mallet is all it took to get the pin out. Once the pin was out I just unscrewed it. Hope this helps.
Just asked this question in the legal forum, but aye, in the states, welded on muzzle brake does change things; here, no. Wanted to get a 16 inch barrel with a welded on flash suppressor, but was a no go in Canada.
What other accessories are you thinking about adding? My XCR comes in this week, and I'm thinking about some iron sites for starters, an Atlas bipod + forward grip, magpul UBR stock, and some pmags if I can find any...
-Feliks
What other accessories are you thinking about adding? My XCR comes in this week, and I'm thinking about some iron sites for starters, an Atlas bipod + forward grip, magpul UBR stock, and some pmags if I can find any...
-Feliks
