Rollsizing?

[Sniffer]

I tried this in General but did not get any bites so here goes again.

Anyone here use a roll sizer?

I am thinking of picking one up for 9mm as I have a ton of cases (two full 5 gallon pails) to clean / deprime / resize and a good few seem to have noticeable Glock bulge.

The Rollsizer.com DC drive mini looks like it would be a good fit as I can feed it from my Dillon case feeder so it would be somewhat automated and can process 1500 cases / hour which would be more than sufficient.

Thoughts?

 

[Sniffer]

Bump.

Still looking into this and have found a few other brands but keep coming back to Rollsizer.

They have the DC unit which I mentioned previously and a commercial version, not sure which way to go but want to figure it out soon as Black Friday is almost upon us and I am hoping for a deal.

I found an old thread on here about these units / group buy and it sounded like anyone who didnt go with the commercial version regretted it but looking at the numbers the smaller / cheaper DC unit would work fine (my plan is to clean / deprime / roll size / size / prime the brass in winter, load & shoot all summer and then repeat in winter again so I would be doing one big batch once per year). That thread has made me think though because it seems every time I go with the cheaper option I end up "upgrading" eventually which costs me more in the end.

And I am up to three 5 gallon pails of 9mm to feed it when it shows up