Ruger 10/22 trigger group pins keep falling out.

[ajayofcanada]

Ever since the day I got the thing in the mail from Wholesale Sports, the pins have been very loose in the trigger group, I have my trigger group within a krinker stock so you can't see any of it, but their is still enough room for the pins to slide halfway out inside the stock. I've tried tape, which works well for a few weeks, but it looks Bubba when duct tape is visible around the mag release.

I was going to try some clear nail polish but thought I'd ask here in case someone has a different solution they used, dawn Ruger and these new plastic trigger groups, I hope they switch back to metal, IMHO, if it ain't broke don't fix it.

 

[Jahred.F]

this may be your best solution: http://coolguyguns.com/8Pins.html

best of luck!

 

[Nonus]

When I took my plastic trigger group out to work on it the pins would always slide out too. I guess the plastic one isn't as good as the metal one.

I upgraded to a metal trigger assembly and the pins stay in there nice and tight. I guess that could be one of your solutions

 

[ajayofcanada]

Thanks!

 

[Ren]

Totally normal, put a bit of masking tape on either side and they will stay in place.

 

[beergut]

hot melt glue

 

[Juster]

Loonie store 3/16" drill bit, cut to length. You can stake or wack the bit with a hammer to make it a tighter fit.