Ruger Marlin 1894 44mag Feeding Issues

[Sinasta]

Even when cycling the action very hard. I will still have feeding issues. It's like the back end of the round doesn't get high enough to rest against the bolt face. I have removed the extractor and ejector to see if they were causing the issues but they weren't.

I've tried multiple different factory rounds from flat point, round nose to hallow point and all are the same.

 

[kamlooky]

I’d contact Ruger warranty.
Be sure to tell them factory rounds only.
No reloads have been used.

 

[madtrapper143]

Run the rifle without the extractor. Could be some surprising results. Do not modify anything yet.
Darryl

 

[Simpson302]

Have you tried tightening all the action screws?
When i got my used JM stamped 1894 I had similar issues, read online somewhere try action screws. sure enough most if not all loose. fixed the problem for me.

 

[Sinasta]

Run the rifle without the extractor. Could be some surprising results. Do not modify anything yet.
Darryl

Yes I removed extractor and ejector as stated.

 

[Sinasta]

Have you tried tightening all the action screws?
When i got my used JM stamped 1894 I had similar issues, read online somewhere try action screws. sure enough most if not all loose. fixed the problem for me.

Yup just double checked them.