Ruger Precision 22. Check pad.

[Brendonvodden]

Recently purchased ruger precision 22. Even at highest position my check pad is too low. Anyone have link for higher check pad or work around ?

 

[adamg]

Use lower scope mount?

You can turn around the cheek pad so it faces backwards, if that helps.

 

[Buck1950]

^ ^ What equipment ? I use Vortex Pro LOW rings up to 50mm bell and Varmint barrel (Savage B22FV & CZ455) with a kydex cheek riser on the Savage (Amazon Mathews clone ca $40).

 

[boxhitch]

.....................

 

[IanC]

Personally I would find a sheet of kydex, google can help with that. Trim and form it to any shape you need and figure out a way to fasten it to the existing cheek piece. Or a not so pretty but cheap method pipe insulation.

 

[Buck1950]

For a sheet of 0.125" plus shipping plus attaching hdwe, you can buy a Matthews 'clone' - ca $40 - ready to mount. Granted you'll have 'left-over' kydex to make more but unless you have a low-cost source for mounting ?

 

[Back Country Hunter]

If you want to build up the existing cheek riser I have seen computer mouse pads cut to shape and glued on or held in place with two-sided tape. Foam pipe insulation also works if you need more height as you can stack pieces on top of each other and then use cloth tape to hold everything together.

 

[Buck1950]

Alien Tape !!! And use clear plastic like soda bottle so you can see the grain . . .

 

[Max Owner]

Not sure if Solely Canadian’s cheek riser would go over top of factory cheek riser. Plus it can be used on other rifles too.

 

[J10archer]

That's the downside is the handguard. Higher than desired rings are needed for clearance. Cut and twoside tape some foam to get what you need. Then use the new price to make something more permanent and pleasing. It's just plastic. Drill for hardware if you want.