SAECO Lubri-Sizer

M

Moose_Master

CGN Regular
Rating - 100%
29   0   0
Location
Montreal
I am eyeing a Saeco lubri-sizer in the States but is quite expensive and before dipping my hand in the pocket I said I better ask first about it.
Any of you own or used one?
It looks very sturdy and what I like is the two guiding rods that offer great precision (or they should) when pulling the lever.
Thanx
 
you dont need all the accessories. You dont need any in fact. just the lubri sizer with the proper size die.
if you want a lubri sizer, it's the one to get.
 
I knew I should have not ask the question. I just knew it. Now you fired me up so bad that all I can think is how to get the darn thing. Here I go again with more buyin.
I watched a video on youtube with the magma lubri sizer and that thing is smokin hot.

Ok, now that you bugged me at least tell me what else beside the machine I need so I know what to look for.
 
Pay attention to the STAR instructions for setting the sizing die in place - you want to get the injection holes lined up at the proper height on the bullet lube rings when the handle trips the injector plunger. Probably sounds more complicated than it is to do. You can read the STAR instructions on-line from the Magma site, if you want. I have about 6 dies for my STAR and at least that number of Lee Sizers - sizing nose first has no downside that I have ever found.
 
OK is decided. I'll get the Star lubri-sizer. Also I think I will sell my RCBC Pro-melter and buy the Master Caster also from Magma.

Thank you kindly gents for all the input.
 
You must log in or register to reply here.
Back
Top Bottom