scope and rings for cz452 standard

[bradmclean]

do you guys have any recommendations..........thanks brad

 

[lejarretnoir]

I use the Burris Signature Zee rings Medium.
Any scope 40mm objective and under will work with those and clear the bolt handle.
I just have an older 4x Weaver on mine. All I need for practice and hunting.

http://xs537.xs.to/xs537/09110/img_5578682.jpg

 

[horseman2]

Josef Dlask, President,
Dlask Arms Corp.,
202B 1546 Derwent Way,
Delta, BC, Canada, V3M 6M4
Tel.: 604-527-9942
Fax: 604-527-9982
jdlask@telus.net
www.dlask.com

 

[bradmclean]

thanks guys,i do have a pretty cool little 4x32 rws scope that fits between the rear site and the breach.josef,is that rail something you make? thanks brad

 

[lejarretnoir]

Dlask Arms makes those rails, but last time I checked he had none in stock and wouldn't give me any date when he may make a run of them again.

 

[bradmclean]

is that an american i see a picture of,my problem is i want to leave the rear site intact and get the objective as close as i can to it without touching it.

 

[Grizzlypeg]

If you have an American, it uses 3/8 dovetail or tip off rings. I'm using medium Leupolds on mine with a 40mm scope and it fits properly IMO.

 

[bradmclean]

no,mines a"standard" or "lux"...........iron sights

 

[horseman2]

The picture is a 452 Varmint

 

[lejarretnoir]

Either the rail or tip off rings in 11mm will work if you have the Lux. Only the American model has the 3/8" dovetail. Just make sure the scope is short enough and just behind the rear sight.

 

[bradmclean]

ya, i might have to go with the high lynx rings and get it over with.if i mount my 4x32 rws shorty it really messes with the bolt