I've got a B&L Elite 3000 3-9x40 which I recently installed in Sako Optilocks on a 300WM. This scope has been on this rifle for 8 years, just with different mounts. I guess I didn't tighten the Optilock rings enough because after my last range session the scope had slid forward as far as it could (the magnification ring was pressed up tight against the rear base). I keep the scope on 9x at the range so I didn't notice that it wouldn't budge.
Anyway, I loosened the rings, readjusted the scope and tightened it up. Now when I've got the scope on 3x there's a little black spot on the bottom of the vertical crosshair. If I move the ring slightly (like .5cm) more than 3x, it's gone. It appears to be sitting if front of the crosshairs (ie, closer to the eyepiece) and appears to be a small plastic shaving.
Anyone ever have this issue? Like I mentioned, I've had the scope for 8 years and it hasn't been babied. Do you think it would be worthwhile sending it to Bushnell in this condition?
Thanks!
Oops, can someone move this to Optics, please.
Anyway, I loosened the rings, readjusted the scope and tightened it up. Now when I've got the scope on 3x there's a little black spot on the bottom of the vertical crosshair. If I move the ring slightly (like .5cm) more than 3x, it's gone. It appears to be sitting if front of the crosshairs (ie, closer to the eyepiece) and appears to be a small plastic shaving.
Anyone ever have this issue? Like I mentioned, I've had the scope for 8 years and it hasn't been babied. Do you think it would be worthwhile sending it to Bushnell in this condition?
Thanks!
Oops, can someone move this to Optics, please.

Last edited:




















































