Scope rings for Tavor

[TheCircle]

removepls

pls remove

 

[hbean]

How much is "not going to break the bank"? Pretty much anything over 1" high will do the job, you just have to figure out what is the size of the tube? an inch, 30 mm or 34 mm, QD or bolt on, one piece or two piece?

 

[jparent]

Extra high's are what you need.

I just happen to have some for sale in the EE....

 

[TheCircle]

Those rings wont work. Sorry I should have specified that it is a 1" tube.

 

[TheCircle]

How much is "not going to break the bank"? Pretty much anything over 1" high will do the job, you just have to figure out what is the size of the tube? an inch, 30 mm or 34 mm, QD or bolt on, one piece or two piece?

Its a 1" tube. I am not worried about the actually mounting itself, as long as it can hold zero haha. I just worry about it not being high enough for a good cheek weld.

 

[hbean]

Nikon P series mount retails around $65

 

[TheCircle]

Nikon P series mount retails around $65

Are those going to be high enough for a decent cheek weld? Thanks for the reply.

 

[Rebel Rouser]

https://www.americandefensemanufacturing.com/view/product/5/

 

[hbean]

Yes, I used it on my Tavor before I switched over to a Vortex Spitefire, now it is on my AR.

 

[TheCircle]

Yes, I used it on my Tavor before I switched over to a Vortex Spitefire, now it is on my AR.

Thanks a lot, I ordered some.

 

[hbean]

take a look at this picture it is a one piece M series (30 mm) but it is the same height as the P series
https://www.canadiangunnutz.com/forum/showthread.php/1622405-X95-Optics-amp-config-Recommendations

 

[TheCircle]

Those rings add 20 moa right? I was looking at those but I decided to go the cheaper route.
Looks good!