Shadow 2 failure to extract

[lacroian]

Bullets seated too deeply can increase pressures. May or may not be an issue. I personally would reject a deep seated round if I noticed it while loading a mag.

I do the same

 

[*MALICE*]

This is confusing, thought one of you said that glock doesn't recommend blazer brass.....

I had said glock had agreed with me that the guns kb'ed because of the set back rounds? (4nt20 disagrees with me)
But they never mentioned one shouldn't use blazer specifically.

Maybe that was the confusion?

 

[Gatehouse]

I couldn't help but laugh when I read this part, I can confidently state that you're full of $hit.

It's not inconceivable that if a round is loaded on the maximum side of powder charge, and then the bullet is seated too deeply, the pressures could increase to the point where there is some sort of failure. A number of things could come into play, including how well the case head is supported in a particular firearm.

 

[lacroian]

I had said glock had agreed with me that the guns kb'ed because of the set back rounds? (4nt20 disagrees with me)
But they never mentioned one shouldn't use blazer specifically.

Maybe that was the confusion?

Yes that was the confusion, one thing i can say is that i ruined a barrel while using steel case rounds

 

[Avenida]

The gun has 50K, it simply needs new everything. starting with all springs, the extractor should have been replaced also long time ago or at least inspected.
Barrel life in a CZ is about 30.000 too.

 

[Gatehouse]

The gun has 50K, it simply needs new everything. starting with all springs, the extractor should have been replaced also long time ago or at least inspected.
Barrel life in a CZ is about 30.000 too.

The one with 50k extracts fine, it’s the one with less than 5k that is having intermittent extraction problems.