Sig P226 breach block roll pin question

[DancesWithEmptyCasings]

I have West German Sig P226 for which I bought a factory parts kit. The new outer roll pin the secure the breach block seems to large (.14") and the hole in the slide seems to measure out at .13". Any suggestions folks?

Cheers

 

[DancesWithEmptyCasings]

...

 

[hondroid]

Should be an inner and outer roll pin combo or a large roll pin to hold the firing pin and extractor housing inside the slide. The pin will compress as it is hammered into the slides pin hole. This is to ensure that the pin will not work its way out during firing.

 

[Dsiwy]

It should be 2 roll pins and the large roll pin is very tight. I normally crush the tip in a vice so I can start it in the slide.

Just to confirm this pin you're using is not a silver spiral pin is it?

 

[DancesWithEmptyCasings]

The 2 piece in.