SIG P320 trigger work

[ILLICI7]

Hello all,

Does any one know how I can send my p320 FCU into the states for work? Or does anyone know anyone in canada that will upgrade/tune it.

Thanks in advance

Brandon

 

[marcooool]

Bought Apex advanced flat trigger from Brownell. It’s a 10 minute work and reduced the trigger pull from 6.7lb to 5.2lb. Not on par with hammer fire but good enough for strike fire.

 

[DILLIGAF]

No trigger work needed just buy Apex brownells.com/handgun-parts/trigger-group-parts/trigger-parts/triggers/sig-sauer-p320-advanced-trigger-with-forward-set-trigger-bar-prod116793.aspx

This is mine with it installed. takes literally 5 minutes.

 

[BooSSted]

IRUNGUNS will ship it to the states for you if you insist on sending it down there. There is a thread in their forum about it.

 

[tharkhold]

Are you asking about the Sig VUP, or some actual aftermarket trigger work? If it's the VUP, MD Charlton does it in Canada.

I've done the VUP, and self-installed the Apex bar/trigger also. 5-10min job. The biggest PITA (by far) is that #$%$% "V" spring that one has to put back.

Mine (same thing as dilligaf's):

 

[ILLICI7]

I current have just the xfive trigger installed onto a stock fcu(made after the vup), it's too squishy for my liking. there is also a noticeable "click" at the beginning of the wall before the break. When looking into the back of the gun it's right at the bottom of the sear, so I'm assuming just a bad factory machine job. This is why I dont think the apex bar and trigger will help, I would need a new sear much like how the gray guns kit comes with/installed with, Bruce at gray guns informed me he cannot send that set up to me due to ITAR.

Those of you with the apex installed does your striker sit at the very bottom of the sear?

Brandon