Silly Tapco Question

[cyclone]

Anyone know how to "pluck out" the 2nd part of the screws securing the "straight tube" to the stock?

I want to swap it - finally - for the "bent" tube.....

 

[Tyler]

Straight tube, bent tube?

Huh?

Are you talking about the telescoping stock?

 

[cyclone]

Straight tube, bent tube?

Huh?

Are you talking about the telescoping stock?

Sorta - the black tube that the stock rides on....

 

[Tyler]

It's held on by two bolts. Just unscrew and use a narrow flat-head to poke the nuts out the other end after the bolts are out.

Not hard at all.

 

[cyclone]

Thanks to everyone for their help - the nut was in tight , so (after I took the bolt out with an Allen key) I just slid a narrow/smaller Robertson screwdriver through the aperture and tapped the screwdriver on the end with a hammer until the nut came loose....

 

[lone-wolf]

Thanks to everyone for their help - the nut was in tight

that sounds dirty

 

[cyclone]

that sounds dirty

But you were okay with the words "bent tube"..........

 

[lone-wolf]

you gotta take your nuts out so you can swap your straight tube with a bent one.

Just use ###### buddy