SKS gas piston - parts available?

Many SKS have a bit of corrosion in that spot, both on the gas piston and the gas tube where the piston touches it. Because the SKS is over-gassed, it
should not have much effect on operation. Just stop further corrosion and carry on!;)
 
Does it still run well? I've seen a pretty pitted gas tube cycle an sks flawlessly. Trick is to make sure there is no active rust left so it doesn't get worse.
 
I had a type 54 that the gas piston was so badly corroded it would not move in the gas tube ,just cleaned it up , works fine now, no need to replace it .

I had one in a similar situation. I put mine in a drill and spinned it against a green Scotchbrite pad and then 800 grit sandpaper. Turned it into brandnew.
 
Back
Top Bottom