SKS gas tube end a bit loose and take down latch problem

[noea77]

Hi guys im wondering if anyone can help me with my sks. It still shoots fine but want to fix a few things. First the small gas tube end is a bit loose and wondering if a new nail the same size would fix it and/or putting some JB weld on both end and seal it a bit better. Also my take down latch is completely loose and pops out. The one end doesnt have anymore steel where it can be hammered with a ball peen hammer to fix it. Right now I just have a nut and bolt for the time being when im at the range so it doesnt come loose on me. Can anyone help and/or know a place that would sell a replacement part for the take down latch ? Thanks

 

[edojan]

If you are referring to the receiver latch, it is available from marstar here is the link https://www.marstar.ca/dynamic/product.jsp?productid=81752

For the gas tube see here http://www.leverarms.com/surplus-firearms/sks-parts-accessories/sks-handguard-gas-cylinder.html

 

[weasel1]

Magwedge qwik pin makes an excellent replacement for the takedown lever.

 

[noea77]

Thanks for the info guys. marstar is sold out of the piece I need for the takedown lever for gas tube. For the other part I Might just find a nail thats the right size and chop off both ends and use for the pin on the gas tube for the time being. I dont want to buy the whole gas tube piece and figured a nail is best way to go. I think it got loose over time when I put the tapco stock on