- Location
- At the gettin' place.
Morning all,
I'm looking to use a bolt and nut as a makeshift receiver cover pin until my Kwikpin arrives (had to grind the stock pin), I was hoping someone had done something like this, and had an idea of the width and length of bolt that would be appropriate (width is more important).
I left the old pin at home this morning, I had intended to take it to work to eyeball a temporary replacement but in my agitated state after seeing this mornings snow, I forgot lol.
So, after dredging the internet with no luck regarding dimensions of the pin, CGN, you are my only hope!
Anyone have any ideas?
I'm looking to use a bolt and nut as a makeshift receiver cover pin until my Kwikpin arrives (had to grind the stock pin), I was hoping someone had done something like this, and had an idea of the width and length of bolt that would be appropriate (width is more important).
I left the old pin at home this morning, I had intended to take it to work to eyeball a temporary replacement but in my agitated state after seeing this mornings snow, I forgot lol.
So, after dredging the internet with no luck regarding dimensions of the pin, CGN, you are my only hope!
Anyone have any ideas?
