just got a nice chinese sks, bought 2 receiver mounts to put on scope. these were to be just bolt them on. crap none will fit, 3 to 4 hours at a machine shop maybe. any sugestions. ps mine has 2 rivets on top at rear(under cover) is this normal?
sks scope it??
- Thread starter bjsgear
- Start date
heavyBullet
CGN Ultra frequent flyer
- Location
- Just off the island of MTL
Two rivets ???????
- Location
- Tucson, Arizona
A pic would help but that doeasn't sound right.
heavyBullet
CGN Ultra frequent flyer
- Location
- Just off the island of MTL
Message sent on how to post pic's.
saskgunowner101
CGN Ultra frequent flyer
- Location
- near Prince Albert
From what you're describing, it sounds like your mount requires two holes to be drilled through the receiver dust cover, and then it gets rivetted on??
I think if you want to push the "easy" button, you will inquire around for a replacement dust cover with the rail built in. That's what I have.
Its a bit on the high side, but it allows a scope, as well as being see through, so open sights are still an option. Frontier used to have them.
Remember to get a stubby scope, or you can't load off of stripper clips. Hope this helped.
I think if you want to push the "easy" button, you will inquire around for a replacement dust cover with the rail built in. That's what I have.
Its a bit on the high side, but it allows a scope, as well as being see through, so open sights are still an option. Frontier used to have them.
Remember to get a stubby scope, or you can't load off of stripper clips. Hope this helped.
sks
i guess i got a weird gun, the rivet heads are at the rear of the receiver, about 1/2 inch from rear.both the items i bought are utg makes ,dont even come close to fitting. the rails on the bolt have to slide into this cover and the after market receivers are no way near the same as mine. if one of you send me an email addy i can send pics, bryan.
i guess i got a weird gun, the rivet heads are at the rear of the receiver, about 1/2 inch from rear.both the items i bought are utg makes ,dont even come close to fitting. the rails on the bolt have to slide into this cover and the after market receivers are no way near the same as mine. if one of you send me an email addy i can send pics, bryan.
