Speed feed stock

Y

yes man

CGN Regular
Rating - 100%
21   0   0
Hi just a question ive instaled a speed feed on a 590a1, im wondering what the torque is for the stock bolt
,i screwed it in to the point i felt it would strip and i still have very little wiggle from side to side with the stock.is this normal with these stocks? And has anyone stripped a reciever with one of these it seams wierd to have a steel bolt goin into softer aluminum ? Thx for any help on these questions.
 
Yes by looking at the threads i goes in about 1/2 inch or so in the reciever, wich is about half way of the threads in the reciver so still lots there before bottom out .
 
yes man said:
Yes by looking at the threads i goes in about 1/2 inch or so in the reciever, wich is about half way of the threads in the reciver so still lots there before bottom out .
Click to expand...

lol....im not talking about running out of thread, I'm talking about bottoming out in the reciever. It's possible that the countersink in your new stock is deeper than the stock one, which will make your bolt too long....hence my suggestion to add a washer.
 
You must log in or register to reply here.
Back
Top Bottom