Squires Bingham/Armscor Model 1500

PantherD1943

PantherD1943

CGN Regular
Rating - 100%
17   0   0
Location
Ontario
Hey guys I got a Squires Bingham Model 1500 (says imported by Ruko) and I was wondering what the going value of one is and how to disassemble the bolt. It light strikes but there is no firing pin or chamber damage so I think the bolt just needs a good scrub but I cannot figure out how to disassemble it and all the schematics online don't give instruction. If anyone is familiar with this rifle can you help me out?

Thanks.
 
If I can still recall: Clear the chamber. Pull and hold the trigger. Pull the bolt out to the rear. If you don't have a schematic, try this one:

http://www.gunpartscorp.com/Manufac...ionRimfire-38530/SquiresBingham1500-35525.htm

Or take some pictures for every part you take out.
I usually start with extractor, firing pin and the rest follows. But if you are hesitant in disassembling the bolt assembly, buy a Remington Action Cleaner. Spray vigorously until the excess solvent drips clean. Let it try, and lubricate with your favorite gun oil.
 
ambishooter said:
If I can still recall: Clear the chamber. Pull and hold the trigger. Pull the bolt out to the rear. If you don't have a schematic, try this one:

http://www.gunpartscorp.com/Manufac...ionRimfire-38530/SquiresBingham1500-35525.htm

Or take some pictures for every part you take out.
I usually start with extractor, firing pin and the rest follows. But if you are hesitant in disassembling the bolt assembly, buy a Remington Action Cleaner. Spray vigorously until the excess solvent drips clean. Let it try, and lubricate with your favorite gun oil.
Click to expand...

Sorry I should've mentioned I know how to remove the bolt from the gun but I want to disassemble the bolt itself. Those schematics show it disassembled but I am unclear on how to actually get the bolt that way.
 
You must log in or register to reply here.
Back
Top Bottom