Stag 10 rattle tension screw

[1ABNDT]

Good CGN, was curious if anyone else can notice a slight gap between the upper and lower when holding up to the light. And would this be normal? Ty.

 

[FoxAlpha]

Pretty normal for all AR style receivers and doesn’t effect anything in any negative way.

 

[1ABNDT]

Ty FoxAlpha, I appreciate the knowledge and your consideration.

 

[JohnnyP636]

Good CGN, was curious if anyone else can notice a slight gap between the upper and lower when holding up to the light. And would this be normal? Ty.

Mine has a gap that you can see light between, but even without a tension screw installed the upper/lower is tight with no wiggle. Its just as good if not better then my billet Ar15 upper/lower combos actually

 

[1ABNDT]

Mine has a gap that you can see light between, but even without a tension screw installed the upper/lower is tight with no wiggle. Its just as good if not better then my billet Ar15 upper/lower combos actually

I am experiencing some wiggle between the upper and lower since I installed my PA prism scope, when I hold it by the grip and shake left and right the upper moveand rattles. When I support the stock with my armpit and shake left and right wiggling stops should I be concerned or is this normal when you have added 1 pound to the upper? Thanking you in advance for your time and consideration.

 

[1ABNDT]

Checked the tension screw, it was backed all the way down. Seated it against the post inside the upper and no more rattle. Ah yeah, Sweet Stag10!

 

[JohnnyP636]

I am experiencing some wiggle between the upper and lower since I installed my PA prism scope, when I hold it by the grip and shake left and right the upper moveand rattles. When I support the stock with my armpit and shake left and right wiggling stops should I be concerned or is this normal when you have added 1 pound to the upper? Thanking you in advance for your time and consideration.

Its pretty normal for your average upper/lower to have some wiggle, especially when mixing brands and not starting with a match set like a billet upper/lower combo. I am pretty sure all my billet upper/lower sets have tension screws in them, but to see it in the Stag10 forged lower as standard is a nice feature.