Stock cross bolt: Where to buy?

O

Omenator

CGN Regular
Rating - 100%
52   0   0
Location
BC, Fraser Valley
Looking for a stock cross bolt. Would like to find one of the type Sako used in the AV rifles.
About 1/8" dia threaded rod with two end caps 15mm/.590" dia.
On a similar vein, any good gunsmiths in the BC Fraser Valley, I'm sure one of them would have one.
 
I don't know why a good gunsmith in the BC Fraser Valley may have one over any other type of gunsmith... but just about any gunsmith could custom make you one... I have never seen a supplier of cross bolts for a gunsmith to buy... but I also have never had the need to install one either... I prefer the internal cross bolt that doesn't show.
 
Sako cross bolts are metric, which of course isn't very common in the USA where most things available to use come from. I have made some to the same spec but brownells sells them (factory parts section) or you can also buy a more generic crossbolt (much cheaper than the sako made version) made by talley - also sold by brownells. When I made my sako crossbolts, the hardest part was finding the small metric threaded rod up here. If you want actual specific sizes and measurements, feel free to pm me and I will dig out my notes.
 
You must log in or register to reply here.
Back
Top Bottom