Swiss arms stock?

[TK-Hryciuk]

Hey guys, so my black special came in and for some reason instead of folding the stock to fit it in the case, the retailer took the whole stock off... My question is, where does that little washer that rides against the axis pin go? From the exploded diagram it looks like it goes on top of the stock, just under the receiver hole. Is this correct? And if so what's the easiest way to get it back on?

 

[Kampfhamster]

Have fun putting that little thing back in. It's a .

Some force may be required, but these things don't break so easily. Just make sure it's aligned properly before you push in the bolt.

 

[twyeh]

Washer goes on top if I recall correctly.

Get a chopstick or something with the same diameter.
Washer convex end should face stock.
Line up washer with the chopstick to hold washer through the hole.
Line up stock and slide it in with chopstick holding the washer in place in the hinge.
Pull out chopstick and insert stock hinge pin in.
Done.

 

[TK-Hryciuk]

Hey guys so I got it on no problem but the cup spring was more flat than convexed, will this make a difference? I realigned the washer by judging the side that had finish wear which I assume was because of contact with the receiver and not the stock.

 

[Kampfhamster]

doesn't really matter.

 

[dizzy]

you are good to go, that washer is just little spacer to help the stock line up with the receiver a little better. not a big issue at all, now go shoot the rifle.

 

[Steve Janes]

Have fun putting that little thing back in. It's a .

Some force may be required, but these things don't break so easily. Just make sure it's aligned properly before you push in the bolt.

Agreed....I found that out last year, thought I would never get it back in.