T97 Barrel Threading

[dodgeman316]

I am looking for recommendations on shops that are familiar with barrel threading.
Specifically I have two T97s that I would like to have done.
I am located in Northeastern Ontario and would prefer a shop in Ontario but would also send it out elsewhere if there is a good shop that is familiar with the T97s.
Thanks in advance.

 

[ShawnC6]

Very nice. I'm looking for the same in Calgary or Alberta.

Was quoted at one place at a bit over $300 for one.

 

[Rickster66]

It sounds like a standard lathe operation that most machinists/gunsmiths can perform. It might be cheaper if you can strip down the T97 and just send the barrel out. The shipping costs would be reduced as well as the labour required. Tactical ordinance might be able to help you out. They cut threads into my 590a1 barrel for chokes for me.

 

[dodgeman316]

Thanks for the reply, I will check them out.

 

[baldabe]

Tacord just did mine. Have not picked it up yet.